HOW TO INSTALL

how
to
install


how
to
install


Pre-installation Guide

Before getting started on installing your brand new inus bidet,
let's ensure that you have everything you need:


step 1.

All models require a power plug,
so you will need to make sure there is an outlet near to your toilet.


step 2.

Lay down a towel or a basket on the floor.
There may be some dripping during the installation process.


step 3.

Remove your old toilet seat.
Make sure that you have a wrench and flat-head screwdriver. (Tools are not included)


step 4.

Turn off the water supply to your toilet.
The valve is typically found beside or behind your toilet.

now you’re ready to install your bidet!

please open the manual in the package.

Bidet Installation Guide

Now that you have everything you need, let's get started:

step 1.

Place the plastic mounting plate over the mounting holes. This will be used to prevent your new inus bidet from moving once installed.

step 2.

Use the bolt guides to guide the mounting plate into place.

step 3.

Once you have lined up the mounting plate with the bolt guides, insert the bolts and tighten them from beneath.

step 4.

Now that the plastic mounting plate is firmly in place, place the bidet on top of your toilet, in front of the mounting plate.

step 5.

Use the built in guide rails to slide the bidet backwards into the mounting plate until it hits the back of the the mounting plate.

step 1.

Place the plastic mounting plate over the mounting holes. This will be used to prevent your new inus bidet from moving once installed.

step 2.

Use the bolt guides to guide the mounting plate into place.

step 3.

Once you have lined up the mounting plate with the bolt guides, insert the bolts and tighten them from beneath.

step 4.

Now that the plastic mounting plate is firmly in place, place the bidet on top of your toilet, in front of the mounting plate.

step 5.

Use the built in guide rails to slide the bidet backwards into the mounting plate until it hits the back of the the mounting plate.

Valve installation Guide
Before installation, please double check that you have turned off the water supply to your toilet, and have a towel ready in case there is still some water left in the lines after removal.

step 1.

Disconnect the existing pipeline from your toilet and water supply.

step 2.

Once removed, attach the T-Valve to the water supply valve. This will split the flow into 2 directions, allowing for water to flow into your toilets tank as well as to your new bidet.

step 3.

Now that your Bidet is installed and the T-valve is installed, you can reconnect the your toilet and your bidet to the water supply.

step 4.

Now that you have securely installed your new bidet you can now complete installation by plugging in your bidet to an outlet and turning on the water supply to your toilet!

step 1.

Disconnect the existing pipeline from your toilet and water supply.

step 2.

Once removed, attach the T-Valve to the water supply valve. This will split the flow into 2 directions, allowing for water to flow into your toilets tank as well as to your new bidet.

step 3.

Now that your Bidet is installed and the T-valve is installed, you can reconnect the your toilet and your bidet to the water supply.

step 4.

Now that you have securely installed your new bidet you can now complete installation by plugging in your bidet to an outlet and turning on the water supply to your toilet!